Electromagnetic mat – an accessory for the zapper – converting electricity into waves

Note: the mat requires a zapper, which we offer in a separate auction.

The subject of the auction is a set containing an electromagnetic mat and a dedicated controller. The device works as an addition to your existing zapper, converting the alternating current it supplies into electromagnetic waves with a frequency of 1Hz-10kHz.

Principle of operation and application:

The mat has been designed to support the body in its fight against pathogens. The emitted electromagnetic waves penetrate the entire body and reach the inside of organs and muscles, effectively killing viruses, bacteria and parasites.

The mat is particularly effective against pathogens that attack the entire body, including viruses (herpes viruses, influenza, RSV, coronaviruses), bacteria that cause Lyme disease, and the common Candida fungus. However, its range of action is broader and its effectiveness higher than that of a classic zapper.

The effect of the mat depends on the correct selection of the programme on the zapper, which in turn requires accurate identification of the ailment. If the expected results are not achieved, long-term use of a single, unchanging programme is not recommended.

During the first sessions, especially in the case of long-term conditions, there may be a temporary deterioration in well-being or an intensification of symptoms. This is normal. In such a situation, the treatment time should be limited to short sessions (e.g. 20 minutes a day). The deterioration should not last longer than 3 days.

How to use:

The mat can be placed on a bed or chair, so you no longer need to hold the bars, as is the case with a classic zapper. A zapper is required for operation, which is not included in the set and must be purchased separately. The zapper is connected to the controller using the included BNC cables. It is possible to use other zapper models, provided that they meet the required technical parameters; the use of an incompatible device may damage the controller.

Design and technical parameters:

• Mat: Dimensions: 95 x 40 cm. Made of cotton and soft foam. Inside, there are well-insulated wires that act as an induction coil. The mat has a removable, washable cotton cover.
• Controller: All-aluminium housing. Power supply: 230V AC. Frequency range: 1 Hz – 10 kHz. Maximum power: 100W, power at standard settings: approx. 60W. The controller housing may heat up slightly during operation, which is normal.
• Set contents: Electromagnetic mat, controller, 2 BNC cables (3m and 0.5m long), electromagnetic field meter and Polish user manual in PDF format.

Notes and warnings:

1. This device is not a medical device. The decision to use it is made at the user's own responsibility.
2. The mat must not be used by pregnant women, people with pacemakers, or people suffering from epilepsy or heart disease. There are no studies confirming the safety of electromagnetic waves in these cases.
3. Do not use the mat in close proximity to the head.
4. The mat is equipped with power control. Depending on the settings, the surface temperature may rise slightly, but should not exceed 30°C.
5. The recommended maximum usage time for the mat is 2 hours per day.
6. The voltage inside the mat ranges from 50 to 100V. Do not immerse any parts of the set in water.
7. In the event of mechanical damage to the surface of the mat (e.g. tearing, biting), immediately switch off the controller and return the damaged components to the service centre.
8. Do not open the controller housing due to the risk of electric shock.
9. Do not set the controller operating frequency above 10 kHz.